Announcement

Collapse
No announcement yet.

Schematic Library Grid? mils or mm?

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • Schematic Library Grid? mils or mm?

    First thanks for the videos I'm learning a lot.

    I'm using Altium 18 and there are a few small changes to the interface from your videos.

    My question is what measuring units are you using when creating on the SCH Library? mils or mm?
    As well the grid and snap on the schematic page?

    My components are all kind of an awkward size compared to the ones that you created and don't align well when drawing the wires.



    Thanks





    Attached Files
    Last edited by fazambuja; 05-19-2018, 03:25 PM.

  • #2
    My question is what measuring units are you using when creating on the SCH Library? mils or mm?
    - I leave that default (mils). To place pins, I always keep it default. To draw the lines inside schematic symbol, I make sometimes the grid smaller, but then I always put it back to default.
    Click image for larger version

Name:	image_1559.jpg
Views:	164
Size:	13.1 KB
ID:	8065

    As well the grid and snap on the schematic page?
    - I leave that default units (mils). Sometimes I make the grid in schematic half of default ... so I change it to 50mil.
    Click image for larger version

Name:	image_1558.jpg
Views:	142
Size:	15.8 KB
ID:	8064

    Comment


    • #3
      Thanks. It got a bit confusing with the changes on 18.

      Comment

      Working...
      X
      😀
      🥰
      🤢
      😎
      😡
      👍
      👎