NC Drill

[edward]

Hi Robert,
I am generating the Fab output the Gerber file came out properly, I followed ail your instructions but the NC drill did not come out correctly. It is just a blob. I attached the file in my email the other can you please take a look and see what is going on.

Thanks

[robertferanec]

Hi Edward, and what is wrong with the file?

[edward]

When I import the NC drill into Viewmate. Please see below

[robertferanec]

Try to generate it in mm or mil. I think this may happen if you generate the file in mm / mils (I think, the file is still ok, just ViewMate can't recognize the units?)

PS: When you open the file in text editor, you can see the content should be correct.

[edward]

It work only in mil but not in mm.

[robertferanec]

Thank you edward for confirmation