Designator. continue numbering when copying a component
Martin Bank , 09-18-2019, 11:18 PM
Dear friends. I'm new in Altium..
If i add a component by copy-paste, th designator is off course "?"
When I annotate it resets to number "1"
I want it to continue the numbering.. not reset to "1"
I have off course tried different stuff, but with no luck
Any ideas what to do?
Br.
Martin.
If i add a component by copy-paste, th designator is off course "?"
When I annotate it resets to number "1"
I want it to continue the numbering.. not reset to "1"
I have off course tried different stuff, but with no luck
Any ideas what to do?
Br.
Martin.
Paul van Avesaath , 09-20-2019, 05:18 AM
when in annotion screen you can give an index or start number..
it doesn't do it automatically, you can reset all and re-annotate off course then the number will be sequential..(but that might not be what you want)
since altium uses unique ID's it will forward the new desingators to all components with no problem..
other option is to use " place component" and fill in you start number in your case R222 then it will continu after that wiith R223 R224 etc..
it doesn't do it automatically, you can reset all and re-annotate off course then the number will be sequential..(but that might not be what you want)
since altium uses unique ID's it will forward the new desingators to all components with no problem..
other option is to use " place component" and fill in you start number in your case R222 then it will continu after that wiith R223 R224 etc..
Use our interactive Discord forum to reply or ask new questions.