PCB - Issues with uVias view on specific layers

[robertferanec]

gmezzina23 is L2 configured as a plane or Signal layer?

[WhoKnewKnows]

You can configure 3D view to show you how the layout is. Altium has this video that shows it

https://www.youtube.com/watch?v=qFOh7Jn-dOw

[qdrives]

Is it perhaps the remove unused pads?

[chitransh92]

Hi,
it seems there is some sort of temporary issue with your version.
May be restarting it should help.

or better update it to the latest.

I tried this on AD20 and it is seen fine for me.

thanks.

[gmezzina23]

Hello everyone, I'm using Altium 19.1.7 and I'm doing the fanout for the pad in the below-attached images.


I did the PCB stack-up and I defined a Blind via between L1 and L2 (i.e., Blind 1:2).


Unfortunately, when I place the blind via, it is visible in L1, while it is "hide" in L2 (in monochromatic view). It seems that the uVia does not reach the L2.


Is this a wrong view configuration or what?


Thank you so much in advance!

Sincerely,
GM