You have to register before you can post. To keep this forum out of spammers, every registration is manually approved.
If you know answers on any questions on this forum, please feel free to answer them. (PS: I try to answer at least once a week or when possible, - Robert)
Hi I have found a much better way, create a new rule in design rules>board Outline Clearance, Type a figure in minimum clearance, and the copper will pull back from board edge by this amount
Hi can anyone help, I have just copied the board outline to a polygon pour, assigned a net and re-poured, the copper is going right up to the board edge, how do you pull it back please
Leave a comment: