| FORUM

FEDEVEL
Platform forum

H5007NL information

yunusekmen , 08-04-2020, 02:36 AM

Hello everyone


ı have checked IMX6 project on Curcits maker, ı use H5007NL for my one of project. my MCU is nrf52832 but nrf52832 does not support ethernet interfaces so could you suggest me Ethernet phy ıc pleas
robertferanec , 08-07-2020, 04:27 AM
H5007NL is only a transformer.

To support Ethernet you also may need a PHY chip. If your chip doesnt support ethernet .... hmmm ... that may be quite complicated. Look for a solution with ethernet and use the same / similar hardware & software. Adding ethernet directly to a microcontroller ... is not an easy task ... and do not forget about writing software for it.
yunusekmen , 08-08-2020, 05:27 PM
Hi, thank you for attention!! ı chose W5500 IC for SPI to Ethernet interfaces.
robertferanec , 08-10-2020, 10:08 AM
Nice chip!
chitransh92 , 08-13-2020, 07:53 AM
Interesting to imaging the SPI to Ethernet conversion..
How a point to point interface is converter to Ethernet level interface..

Electronics is fascinating.. :-)
Use our interactive Discord forum to reply or ask new questions.
Discord invite
Discord forum link (after invitation)

Didn't find what you were looking for?