| FORUM

FEDEVEL
Platform forum

Student

SONAL_SINGH , 10-14-2020, 12:15 AM
Is there an option to choose different dielectric material in stack-up? If so, how can i check levels of signal attenuation depending on the dielectric layer chosen?
Lakshmi , 10-14-2020, 12:38 AM
Yes, You can check the signal speed in different layer wrt to different dielectric material(based on dielectric constant(DK) and Loss tangent).
You may have to use an integrity simulation tool to see the attenuation.
This module focuses on PCB layer stackup and management. Module Highlights:00:00 Introduction00:08 Navigating Layer Stack Manager01:08 Exploring the Material...

Stackups for you, so you have more time for doing PCB layout. Hope this helps.Links:- Share your PCB stackups here: https://designhelp.fedevel.com/forum/test...


Thanks.
Comments:
SONAL_SINGH, 10-14-2020, 12:42 AM
Thanks lakshmi!
Use our interactive Discord forum to reply or ask new questions.
Discord invite
Discord forum link (after invitation)

Didn't find what you were looking for?