About issue with Polygon Pour

[mulfycrowh]

Hi everyone,

I have created a polygon between 2 pads with same net name.
The polygon net is set to the same net name.
I cannot pour the polygon.
Any idea?
Thanks.
AD19.

[mulfycrowh]

I made it using Polygon Solid.
Why does it not run with Polygon Pour?

[WhoKnewKnows]

This often happens to me. There are a variety of settings. Check that pour over all same-net objects is selected? If the polygon is small, make sure the threshold for eliminating parts of the polygon below a certain area is set appropriately. Try connecting the pads with a track and see if Altium generates an error. If it allows the two pads to be connected with a track without error, it should allow a polygon pour to connect them too.

[robertferanec]

As WhoKnewKnows is pointing out, that polygon may be too small. Try to uncheck "Remove islands less than the area" -> "In Area" or change the number there.