Announcement

Collapse
No announcement yet.

About issue with Polygon Pour

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • robertferanec
    replied
    As WhoKnewKnows is pointing out, that polygon may be too small. Try to uncheck "Remove islands less than the area" -> "In Area" or change the number there.

    Leave a comment:


  • WhoKnewKnows
    replied
    This often happens to me. There are a variety of settings. Check that pour over all same-net objects is selected? If the polygon is small, make sure the threshold for eliminating parts of the polygon below a certain area is set appropriately. Try connecting the pads with a track and see if Altium generates an error. If it allows the two pads to be connected with a track without error, it should allow a polygon pour to connect them too.

    Leave a comment:


  • mulfycrowh
    replied
    I made it using Polygon Solid.
    Why does it not run with Polygon Pour?

    Leave a comment:


  • mulfycrowh
    started a topic About issue with Polygon Pour

    About issue with Polygon Pour

    Hi everyone,

    I have created a polygon between 2 pads with same net name.
    The polygon net is set to the same net name.
    I cannot pour the polygon.
    Any idea?
    Thanks.
    AD19.
Working...
X