Tweet
Hi guys,
We all see some issues in the AD and may have a suggestion to fix them, some probably very easy for Altium engineers to add or update.
Hopefully, there are looking at forums like this! let's keep our fingers crossed.
1) Using Reports -> Port Cross Reference -> Add to project; it adds the reference address to ports (and in recent version to off-page connectors as well) but only to open documents, if a page is not open, no reference will be added to it! In my opinion, this does not make sense, it should add reference to all pages of the design, either open or not.
2) When I set a design variant as "Set as current", it should stay current all the time, even after reloading the design. It looks when we open and reloads the design, the variant selection goes back to default, for BOM or fabrication data generation cause problem as we think the variant is set to desired one, while it is not! and we have to check it each time loading design, again does not make sense.
What do you say?
We all see some issues in the AD and may have a suggestion to fix them, some probably very easy for Altium engineers to add or update.
Hopefully, there are looking at forums like this! let's keep our fingers crossed.
1) Using Reports -> Port Cross Reference -> Add to project; it adds the reference address to ports (and in recent version to off-page connectors as well) but only to open documents, if a page is not open, no reference will be added to it! In my opinion, this does not make sense, it should add reference to all pages of the design, either open or not.
2) When I set a design variant as "Set as current", it should stay current all the time, even after reloading the design. It looks when we open and reloads the design, the variant selection goes back to default, for BOM or fabrication data generation cause problem as we think the variant is set to desired one, while it is not! and we have to check it each time loading design, again does not make sense.
What do you say?
Comment