Announcement

Collapse
No announcement yet.

About edge connectors

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • robertferanec
    replied
    1) Yes. Simple way is to draw polygon over the pad and your GND on the board and set "Direct Connection"
    2) I do not think it is important from manufacturing point of view. It is up to you how you would like to have it.

    Leave a comment:


  • mulfycrowh
    started a topic About edge connectors

    About edge connectors

    Hi everyone,

    I would like to get an edge connector made of golden rectangles (4mm x 30 mm) spaced by 30mm.
    These rectangles are tied to DGND.
    I I used Footprint Wizard to make the connector.
    The result is attached below.

    Here are my questions:

    1/ We can see that the connection to DGND is only done on the middle of the golden rectangle.
    Would it be possible to have it on the whole length?

    2/ There is an overlapping of the solder mask onto the polygon pour below.
    Should we get rid of it or not?

    Thank you.


Working...
X