robertferanec Please can you help me with this issue , when i do a polygon for some pads it be looks like strange and some times do not connet to it even there is enough space and clearance
Announcement
Collapse
No announcement yet.
problem in polygon poor with vias and pads
Collapse
X
-
robertferanec Can you please help me with this Issue?
When I connect the netlabel with the wire in Schematics it will not connect after updating in PCB. but If I connect the port along with netlabel it will be connecting to PCB. I cant able to understand this problem.
Aso when I connect BUS in the same Net it will also show disconnected.
Comment
-
I agree with qdrives, try to check your scope settings.
PS: Also, I would recommend to use Navigator and browse your schematic to see what is connected where, this may help: https://youtu.be/f7GP6NZs0Ok?t=392
- Likes 1
Comment
Comment