Hi everyone,
I have a datasheet about a converter with pad.
They say:
Vias are optional depending on application, refer to device data sheet. If any vias are implemented, refer to their locations shown on this view. It is recommended that vias under paste be filled, plugged or tented.
How can I manage these vias in Altium ?
Thanks
I have a datasheet about a converter with pad.
They say:
Vias are optional depending on application, refer to device data sheet. If any vias are implemented, refer to their locations shown on this view. It is recommended that vias under paste be filled, plugged or tented.
How can I manage these vias in Altium ?
Thanks
Comment