Announcement

Collapse
No announcement yet.

About several LibRefs on a same row of the BOM

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • About several LibRefs on a same row of the BOM

    Hi everyone,

    as you can check on the attached screenshot, I have several LibRefs on one single row.
    In that case, it is not very obvious to purchase the components.
    Would it be possible to get only LibRef per row ?

    Thanks a lot.


  • #2
    Perhaps the issue is with how items are grouped. I think this is done in the columns tab. Could you share a screen shot of this as well?
    Attached Files

    Comment


    • #3
      Here we are ...

      Comment


      • #4
        It appears your components are being grouped by footprint. I imagine you'll want to stop that and group by LibRef or manufacturer part number or something like that instead.

        Comment


        • #5
          OK.
          Is it possible to save the new configuration (grouped by LibRef) because each time I restart AD I get footprint again ?

          Comment


          • #6
            You can "save" these settings in a JobFile.

            Comment


            • #7
              That's a little bit annoying not being able to save without a job and it explains why I get this grouped by footprint.
              I never asked it.

              Comment


              • #8
                Working with JobFiles allows you "configure once, use every time" and so much more than just the BoM.

                Comment

                Working...
                X