About several LibRefs on a same row of the BOM

[qdrives]

Working with JobFiles allows you "configure once, use every time" and so much more than just the BoM.

[mulfycrowh]

That's a little bit annoying not being able to save without a job and it explains why I get this grouped by footprint.
I never asked it.

[qdrives]

You can "save" these settings in a JobFile.

[mulfycrowh]

OK.
Is it possible to save the new configuration (grouped by LibRef) because each time I restart AD I get footprint again ?

[WhoKnewKnows]

It appears your components are being grouped by footprint. I imagine you'll want to stop that and group by LibRef or manufacturer part number or something like that instead.

[mulfycrowh]

Here we are ...

[WhoKnewKnows]

Perhaps the issue is with how items are grouped. I think this is done in the columns tab. Could you share a screen shot of this as well?

[mulfycrowh]

Hi everyone,

as you can check on the attached screenshot, I have several LibRefs on one single row.
In that case, it is not very obvious to purchase the components.
Would it be possible to get only LibRef per row ?

Thanks a lot.