| FORUM

FEDEVEL
Platform forum

Insert Layer Stack Table in Altium 10

MSleiman , 02-23-2016, 12:19 PM
Hi,

Is there a way to include a complete (filled with parameters) Layer Stack Table in Altium 10?

Thanks,
mairomaster , 02-23-2016, 01:55 PM
Hi MSleiman,

I believe this feature was added in Altium 14. I do not think it is very important though. Normally you will either agree on the layer stack with the manufacturer during the design, or chose the layer stack when placing the order (if it is a cheap manufacturer and you do not have email communication before placing the order).
MSleiman , 02-23-2016, 02:47 PM
Hi Mairomaster,

Yes, I agree with you. I had to make it manually through Excel sheets then copy and paste in Altium. It is required in a Lab course I am taking though...

Thanks,
MSleiman
robertferanec , 02-27-2016, 12:48 AM
@MSleiman I am not sure if it's possible to add it in AD10, but in older versions you could use "Place Stackup Legend". Go to your PCB -> Right Click -> Options -> Layer Stack Manager -> Place Stackup Legend. Press TAB to chage the Columns you would like to see.






Use our interactive Discord forum to reply or ask new questions.
Discord invite
Discord forum link (after invitation)

Didn't find what you were looking for?