-
If it is an artifact from board outline, you may need to go into outline mode: View -> Board Planning Mode. Maybe then it will be possible to delete it? -
Polygon Track (0.00254mm or 0.1mil) which I can't delete!
Hello to all PCB designers!
I'm getting a Polygon Track on the bottom layer, which I think is an artifact from the board outline, and I can't delete it.
It is 0.00254mm wide, so shows up as a Width Constraint error:
Also, it is causing a gap in the polygon pour on the bottom layer because it is not on a net:
Has anyone experienced this, and any ideas on how to select and delete it?
Thanks, Ken
Using: AD15.0
- You have to register before you can post. To keep this forum out of spammers, every registration is manually approved.
- If you know answers on any questions on this forum, please feel free to answer them. (PS: I try to answer at least once a week or when possible, - Robert)
Leave a comment: