custom pad and high voltage gap

[cometa]

Hello
I must to create a custom pad like in photo 1 and also a high voltage gap photo 2
can somebody explain to me how i do this?

Photo 1 for pad
https://image.ibb.co/mGn7En/pads.jpg

Photo 2 for gap
https://image.ibb.co/iFFzS7/high_voltage_gap.jpg

[alferdvidal]

Hi cometa
If you want to create a pad in image 1, you need to have a padding dashboard and create it in the Altium library.
If you explain more, I might be able to help
Regards
Alfred

[cometa]

Hello,
My pad from pic1 i want to have 3X4mm,
I attached picture, but also please tell me how can i create this,
Thx

[alferdvidal]

Hi cometa
You can create a fill of 3 × 4 on the board and put three pads on it and give it the desired net.

https://youtu.be/vhOWtjPu9U8
https://www.altium.com/documentation...ill((Fill))_AD
In Figure 2 you have an electric discharger that I do not know
I hope that I will help you
good luck

alferd

[cometa]

Thank you Alferd !

[alferdvidal]

you welcom

[robertferanec]

cometa, as alferdvidal sugegsted, you can create schematic symbol with three pins, place it into schematic where it should be connected and create footprint for that symbol. Some time ago I created a video how to create symbols and footprints, this may help you: https://youtu.be/65hJw_dM5Jk

The second footprint - you could create it for example as a 2 pin component. So create a 2 pin symbol and assign special 2 pin footprint to it. The question is how to create the zig zag there - maybe create custom pads: https://www.altium.com/documentation...ad+Shapes))_AD

[alferdvidal]

Thank you so much Robert