Warning message in exporting gerber

[robertferanec]

Interesting, that it was not fixed by the db doctor. If everything looks ok, then you can ignore it (or you can try to correct / redraw it in the logo footprint)

[MrSun]

Did you find the Arc? Could you take screenshot of the arc? Maybe it is very small?

thanks RF,the location is the logo.I think i can ignore.

[robertferanec]

Did you find the Arc? Could you take screenshot of the arc? Maybe it is very small?

[MrSun]

hello,everyone
when exporting gerber files,the following warning occured:

================================================== ==============
PROCESSING FILM < 03-TOP_SOLDER >
TO FILE < D:/workspace/Cadence/1.My Design Projects/1.IS6236A/V1I1/IS6236A_V1I1_03-TOP_SOLDER.art > ...
================================================== ==============

FILM PARAMETERS :
---------------------------------------------------------
Undefined line width 0.0000
Mirror code NONE
Rotate angle NONE
Offset x: 0.0000
Offset y: 0.0000
Plot negative NO
Suppress unconnected internal pads NO
Draw holes only NO

WARNING: Arc segment with end points of
(13.64, 4.36) and (13.92 4.36) converted to a line.
Its center location (13.61 104.72) is too large for
specified integer accuracy of 2 places.

how to fix it？