Announcement

Collapse
No announcement yet.

Misaligned PCB Trace

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Misaligned PCB Trace

    Hi. I took your course Allegro Essentials.

    When I open the finished design, as-is, I can see the traces and they are aligned to the middle of the pin, as expected. However, if I delete the trace and and draw it myself it is not aligned to the center. See attached.

    Note that I copied the design from your final board and then deleted all etch. Then I tried to place a trace and got this result, not centered.
    Attached Files

  • #2
    Maybe you have snapping turned off? When routing, try right click and check snapping option.

    Comment

    Working...
    X