| FORUM

FEDEVEL
Platform forum

Export logo company .ai to allegro

Juan , 01-30-2018, 02:31 AM
Hello

My question is how i can import the logo company .ai in my design PCB, i have proved to convert the .ai in dxf and import to Allegro16.6, but the logo is bad and the logo not is shown complete

Thanks in advance
robertferanec , 01-31-2018, 09:45 AM
When I need to import logo, I create a new Mechanical symbol and import it as an image. Maybe that could help you?



Juan , 01-31-2018, 10:45 PM
Hi Robert:

Thanks in advance, yes i have probed this, but i don't have the option to import-logo in my Allegro version,it is depend of the license ? Or i need configure anything?

Thanks
robertferanec , 02-01-2018, 07:57 AM
Import LOGO option is only available when you are creating mechanical component: File -> New -> Mechanical symbol. The option is not available when you are editing board (brd file)
Juan , 02-02-2018, 05:31 PM
Many Thanks Robert, At the end i have could import in .dxf and to save like mechanical symbol. Best Regards
, 07-22-2019, 07:09 AM
Dear sir , even though i' am trying to import logo in mech symbol editor but i haven't found logo option please find the attached ref image
robertferanec , 07-24-2019, 07:21 AM
Guest, hmm, do you use Allegro 17.2? Maybe you have a different version?
, 08-01-2019, 04:50 AM
yaa its there sir ,thanks .
, 08-01-2019, 04:55 AM
sir i have a question ,when i am generating schematic pdf the pages aren't in a order .like example if we have 8 pages schematic first pages goes to 7 in pdf ,viceversa
robertferanec , 08-02-2019, 07:26 AM
Did you set page numbers in your schematic sheets?
, 08-05-2019, 06:11 AM
i haven't check the schematic page numbers.it is ok now
Use our interactive Discord forum to reply or ask new questions.
Discord invite
Discord forum link (after invitation)

Didn't find what you were looking for?