Export logo company .ai to allegro

i haven't check the schematic page numbers.it is ok now

[robertferanec]

Did you set page numbers in your schematic sheets?

sir i have a question ,when i am generating schematic pdf the pages aren't in a order .like example if we have 8 pages schematic first pages goes to 7 in pdf ,viceversa

yaa its there sir ,thanks .

[robertferanec]

Guest, hmm, do you use Allegro 17.2? Maybe you have a different version?

Dear sir , even though i' am trying to import logo in mech symbol editor but i haven't found logo option please find the attached ref image

[Juan]

Many Thanks Robert, At the end i have could import in .dxf and to save like mechanical symbol. Best Regards

[robertferanec]

Import LOGO option is only available when you are creating mechanical component: File -> New -> Mechanical symbol. The option is not available when you are editing board (brd file)

[Juan]

Hi Robert:

Thanks in advance, yes i have probed this, but i don't have the option to import-logo in my Allegro version,it is depend of the license ? Or i need configure anything?

Thanks

[robertferanec]

When I need to import logo, I create a new Mechanical symbol and import it as an image. Maybe that could help you?

[Juan]

Hello

My question is how i can import the logo company .ai in my design PCB, i have proved to convert the .ai in dxf and import to Allegro16.6, but the logo is bad and the logo not is shown complete

Thanks in advance