Announcement

Collapse
No announcement yet.

i.MX53 Base Board - Questions about electronics

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • tpr
    replied
    Thank you very much for your response!

    Leave a comment:


  • robertferanec
    replied
    Sometimes buffers are used to improve signals (to make them stronger and keep the signal quality good) e.g if the tracks travel too far or if more chips and connectors are connected.

    Leave a comment:


  • tpr
    replied
    For second question i have already the answer and i took that from robert's video with Min about emc improvements!

    But for the first i am going wait your answer/suggestions

    Leave a comment:


  • tpr
    started a topic i.MX53 Base Board - Questions about electronics

    i.MX53 Base Board - Questions about electronics

    Hello,

    During my course, i started reading schematics and i appreciate if you could answer to me some of my questions.

    At first, i notice that all CPU's GPIOs are buffered with level translators IC (e.g 74LVC8T245 / ) but with the same voltage potential. (the two levels are 3V3 but with a ferrite bead or resistor). This is recommended for protection level and how is this explained?

    Second, there is a common mode choke (L905), i know the theory of using something like that, but i dont know how can i decide for the exact inductance. (10mH) also i have the same question for emi filter choice (NFM18PC105R0J3).

    Thanks in advance!
    Thanos
Working...
X