Android OS on Openrex

[jarrodT]

Hi I've recently purchased an OpexRex board and I've been having some difficulty with installing Android OS. It was shipped with Linux Terminal.

This was the guide I was following.

http://www.imx6rex.com/software/how-to-test-android-on-imx6-rex/

I've followed the steps but when hooking up the board to a display using HDMI, I receieve "No Signal". I'm not entirely sure what went wrong during the installation. Several things I've noticed is that when I run this script:

sudo ./fsl-sdcard-partition.sh -f /dev/sdb

I get an output that looks like the image attached.

Did I do something wrong? I wasn't sure how to complete the "Initalize Boot Loader" step, as it tells me in a different guide (the one on voipac), where it says to get "uboot". Well I attempted to do so but I was unable to register on NXP to obtain such information (didn't receive an email).

Is it possible to obtain another explanation of the steps that I must undergo in order to install Android OS?

Thank You,
OpenRex Customer

[robertferanec]

These images are for the iMX6 Rex module (it's a different board). The best is to double check with VOIPAC ( http://www.voipac.com/ ). I know they are planning to port Android on OpenRex, I am just not sure what the current status is.