iMX6 Advance PCB Course

[uday1028]

In Address Line we used Micro via From L1 to L2 and L2 to L3,but why we not used via from L1 to L3?
What Is the Refrance cut in High Speed Layout?

[robertferanec]

- This should answer your uVIA question: https://www.fedevel.com/designhelp/f...=9311#post9311

- "Refrance cut" - I am not sure what you mean

[mairomaster]

Pure guessing here, but maybe splitting the reference ground plane?

You should try to avoid routing or having voids on reference planes, because that might affect the signal integrity of hight speed signals running above them. This happens in the case when return currents cannot travel directly under the high speed signal because of void in the reference plane.