-
It may depend on board and application, but yes, I prefer to route inside of PCB. However I am careful about VIAs e.g. I may use uVIAs or buried VIAs to minimize VIA stub in tracks (if possible). -
High Speed Routing
Robert.....just finished Lesson # 4 in "Advanced PCB Course" and granted I had to go through it fairly quickly. I was under the impression from the video that you are saying it's better to do high speed routing on the internal layers vs. TOP / BOTTOM layers, despite using VIA's....would this be a correct assumption?
- You have to register before you can post. To keep this forum out of spammers, every registration is manually approved.
- If you know answers on any questions on this forum, please feel free to answer them. (PS: I try to answer at least once a week or when possible, - Robert)
Leave a comment: