| FORUM

FEDEVEL
Platform forum

Draw Pcb of MMC Reader

mostafa222 , 10-19-2021, 11:39 PM
Hi Dear Robert.
I Have two MMC Socket that i want to connect them to MMC Port Of Microcontroller like below picture.
at one moment, only one socket is used. i have two question
1. what topology should i use to draw pcb so i did not loose speed?(T Branch or FlyBy or ...)
2. where should i place pull up resistors(at the end side of one of socket or i must place pull up resistors for each socket)?

qdrives , 10-21-2021, 05:17 PM
First simple question: what are the distances?
mostafa222 , 10-22-2021, 12:40 AM
From micro to each socket, 3 cm
robertferanec , 10-23-2021, 01:44 AM
Not an ideal situation. However, if I would have to, I would use fly-by and I would place the one which will be used more and has higher speed as the second one. Still I would try to keep the distance between the pads of the first socket and pads of the second socket very short (e.g. maybe I would place them on the top of each other). If termination resistors are required I would place them at the end of the tracks (behind the last socket).
mostafa222 , 10-24-2021, 10:50 PM
Thanks so much
ibocakir06 , 10-25-2021, 10:16 AM
I would not do this as you talked about above.

You should use an SDIO switch/multiplexer.

robertferanec , 10-25-2021, 10:35 AM
You should use an SDIO switch/multiplexer
- @ibocakir06 is right, that would be the proper and best solution
Use our interactive Discord forum to reply or ask new questions.
Discord invite
Discord forum link (after invitation)

Didn't find what you were looking for?