You should use an SDIO switch/multiplexer
Announcement
Collapse
No announcement yet.
Draw Pcb of MMC Reader
Collapse
X
-
I would not do this as you talked about above.
You should use an SDIO switch/multiplexer.
- Likes 1
Leave a comment:
-
Not an ideal situation. However, if I would have to, I would use fly-by and I would place the one which will be used more and has higher speed as the second one. Still I would try to keep the distance between the pads of the first socket and pads of the second socket very short (e.g. maybe I would place them on the top of each other). If termination resistors are required I would place them at the end of the tracks (behind the last socket).
Leave a comment:
-
Draw Pcb of MMC Reader
Hi Dear Robert.
I Have two MMC Socket that i want to connect them to MMC Port Of Microcontroller like below picture.
at one moment, only one socket is used. i have two question
1. what topology should i use to draw pcb so i did not loose speed?(T Branch or FlyBy or ...)
2. where should i place pull up resistors(at the end side of one of socket or i must place pull up resistors for each socket)?
1 PhotoTags: None
Leave a comment: