| FORUM

FEDEVEL
Platform forum

mcu , rx , tx

samfe , 05-09-2016, 01:44 AM
hello everyone ,

i'm a beginner with altium , tx pin has no driving source when i put it output ,, and when i changed to input i had no warning .
the same thing with sim 800 , the error is he same with pin tx when it is output .
so i can't have a communication between the two .
why this error appear ??? how can i solve it ???
robertferanec , 05-09-2016, 02:28 AM
Hello @samfe. We do not set pin types, we keep them all passive. The main reason is, that a lot of pins can have alternate functions and it was causing a lot of problems - especially during Error Check. Using PORTs can help you with Error Check a little bit (e.g. altium can check if multiple output PORTS are not connected together), but this PIN/PORT checking is not implemented very good in Altium. Maybe they improved it, but just couple of days ago I have seen similar post: http://www.fedevel.com/designhelp/fo...le-input-ports
samfe , 05-09-2016, 03:34 AM
thank you @robertferanec
Use our interactive Discord forum to reply or ask new questions.
Discord invite
Discord forum link (after invitation)

Didn't find what you were looking for?