DRC related error and DRC settings.

[Serpil]

Hello , I have same problem but it's related to Doviashielding. In circuit there is no polygon but it gives this error

[Poo]

Ok...Thanks again.

[robertferanec]

Altium is "famous" for crashing. There are some certain situations or configurations which will consistently crash. Usually restarting Altium helps, if not, you need to find a different way to do the thing which cause crashing.

I do not have preferred DRC settings, as I sometimes change them during design process (e.g. enabling/disabling "Un-Routed Net"). Normally I do not use things like "Testpoint" or "Signal Integrity", but the other rules are usually checked.

When working with DRC, I recommend to use PCB Rules and Violation window (go to your PCB, go to the bottom right corner, click on PCB -> PCB Rules and Violations). Browse through the Rules, double click on Violation and try "Jump" & "Highlight" buttons. See the attached screenshot.

[Poo]

Yes its working ...Thanks....but I hope its not a big issue ...well, if possible can you plz suggest me about DRC violation Display correct setting( as its highlighting all the component rather it should highlight only DRC affected component , is there any prerequisite setting for it as its not working properly?) and any video which shows actual routing of complex board with DRC evaluation.(Last suggested video has a very little routing). Thanks In Advance..

[robertferanec]

I would try to switch off and on Altium. That sometimes helps.

[Poo]

While running DRC I got error massage as

" Access violation at address 2578938B in module 'ADVPCB.DLL'. Read of address 000001C8 at 2578938B.

Exception Occurred In
DesignRuleCheck

Suggestions please.