| FORUM

FEDEVEL
Platform forum

28 pins Project

Eoliveira , 09-14-2018, 08:13 AM
Hello Everyone !!

Hello Robert !!!

Could you help me ?

In arduino 28 pins Project We use via with 0.3mm hole size ....

I was watch notes about hardware design, Via Aspect Ratio.

My questions is ...

1. What kind of vias We use in this project ? I think ... Blind vias ??? . Am I correct ?

2. The thickness of board is 1.6mm , Is enough to use a Via this type to connect TOP e BOTTOM Layer ?

Sorry I'm a little confuse about this

Thank you





robertferanec , 09-17-2018, 12:19 PM
1) Through hole VIAs.
2) It is fine. Usually the ratio is 1:10 or 1:12. For this kind of board, usually the smallest through hole can be 0.15mm .... this means, 0.3mm is perfect and it is also cheap.
Use our interactive Discord forum to reply or ask new questions.
Discord invite
Discord forum link (after invitation)

Didn't find what you were looking for?