| FORUM

FEDEVEL
Platform forum

About COM Express Type 6 and PCB Design

mulfycrowh , 11-29-2019, 05:18 AM
Hi everyone,
Would put components under the COM Express module on the carrier board?
Thank you.
robertferanec , 12-02-2019, 03:04 AM
There are several types of the boards and connectors, so it depends on specific cases (for example you can have 5mm stack, 8mm stack). I have seen boards with both - with components and also without components under the module. Probably, the biggest questions would be if there is space for it and what about heat.

Have a look at a COM express manufacturer website for example here: https://www.kontron.com/products/boa...luation-boards

mulfycrowh , 12-02-2019, 03:20 AM
My question was more about EMI issues for example.
robertferanec , 12-03-2019, 04:53 AM
In my opinion, if layout is properly done and you do not place high noisy circuits there (e.g. power supplies), EMC/EMI should not be a problem.
Use our interactive Discord forum to reply or ask new questions.
Discord invite
Discord forum link (after invitation)

Didn't find what you were looking for?