| FORUM

FEDEVEL
Platform forum

Opamp output at VCC OFF condition

jebin , 10-04-2018, 07:36 AM
Hi,
My requirement is in power off condition i should not feed input voltage to the Processor IO,s (IO i used Level translator)and ADC channels. To do that what i did is i have used LM324LV Op-amp in voltage flower configuration and Opamp VCC will be controlled by Processor.

Conditions:-
i am feeding voltage input to op-amp Non-inverting Pin (+) and op-amp VCC is OFF.
example : Non-inverting pin input voltage - 0.8V and VCC 0V (OFF) and op-amp configured as a Voltage follower.

Question:
In this condition what would be op-amp output will be 0V? or 0.8V? or ...?.


Jebin
mohsin_qau , 10-04-2018, 08:34 AM
Can you please send the Schematics for better understanding
robertferanec , 10-08-2018, 03:13 AM
This is what we used, page 24: http://www.imx6rex.com/wp-content/up...Production.pdf

PS: Maybe have a look also at analog switch chips. I have never used Opamps for this purpose, but it may depend on the rest of the circuit.
jebin , 10-21-2018, 09:19 AM
I have used Analog switch(SN74HC4066DR) for this purpose.
Use our interactive Discord forum to reply or ask new questions.
Discord invite
Discord forum link (after invitation)

Didn't find what you were looking for?