Footprint from Gerbers using Camtastic?
alferdvidal , 08-02-2019, 01:44 AM
Hi, Guys
A question:
How can I give Footprint from Gerbers using Camtastic?
I have a Gerber file and I want to find the component vai Gerber,
Is it possible?
A question:
How can I give Footprint from Gerbers using Camtastic?
I have a Gerber file and I want to find the component vai Gerber,
Is it possible?
robertferanec , 08-05-2019, 08:26 AM
I do not think that you can directly work with footprints in gerber files (unless you are working with more complex outputs e.g. ODB++).
However, there may be some methods how to import gerbers into PCB and then maybe create footprints from there. Here are some examples:
- https://www.onethesis.com/2017/03/24...-to-footprint/
- https://www.eevblog.com/forum/altium...-to-footprint/
However, there may be some methods how to import gerbers into PCB and then maybe create footprints from there. Here are some examples:
- https://www.onethesis.com/2017/03/24...-to-footprint/
- https://www.eevblog.com/forum/altium...-to-footprint/
alferdvidal , 08-05-2019, 11:53 AM
Hi, Robert
Thank s a lot
I will check and inform you soon
Thank s a lot
I will check and inform you soon
alferdvidal , 08-06-2019, 03:06 PM
HI, Robert
Have a good time
Finally i did that
You can find in this link work stages :
Have a good time
Finally i did that
You can find in this link work stages :
Comments:
Kerkraft, 03-08-2021, 09:40 AM
Hello, I have the same beginning steps but when I extract the netlist I get the following error Netlist extraction error: Missing drill layer. have you seen this before?
alferdvidal , 08-06-2019, 03:09 PM
If you have any points inform me please
Thanks in advance
Thanks in advance
robertferanec , 08-07-2019, 12:05 AM
How did you do it? Imported to PCB and then created footprints?
alferdvidal , 08-07-2019, 12:46 AM
Hi, Robert
I sent you in the link work stages
I sent you in the link work stages
Use our interactive Discord forum to reply or ask new questions.