| FORUM

FEDEVEL
Platform forum

Diff Pair distance issue / Course2_Lesson9

Geombu , 02-22-2019, 12:25 PM
Hello all,
I'm facing an issue currently on lesson 9 (using Altium 16.0), where I setup the differential pairs routing rules per Robert's instructions and PPT reference file, but the distance between the 2 pairs is always 0.25mm. So, the rule for Layer 1 is 0.095mm width and 0.155mm distance. The wire width is correct, but the distance is somehow stuck at 0.25mm.

Can anybody provide an advice?

I have tried to delete the rule and set it up again, I have checked if it conflicts with other clearance rules, I save and recompile every time and right after the tun the DRC Check, and nothing. Even restarting the AD16, doesn't help.

I would appreciate any help.

Thanks and regards,
George
Geombu , 02-23-2019, 02:29 PM
Hello all,
This was my mistake. I was measuring with measure distance instead of measure primitives. So the sum of 0.155 plus 0.095 is 0.25, so it is actually working fine.

Thanks and regards,
George
Use our interactive Discord forum to reply or ask new questions.
Discord invite
Discord forum link (after invitation)

Didn't find what you were looking for?