Announcement

Collapse
No announcement yet.

R0 ohm

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • qdrives
    replied
    Ant1882 You would need to see the bigger picture (schematic and layout) if this could be for EMI.
    For the reset I would rather pick a 1k resistor or so, as this allows you to physically reset (during development) with damaging anything.

    Leave a comment:


  • Ant1882
    replied
    I'm guessing in this case it gives you a chance to add a small series resistance if you have issues with radiated EMI maybe?

    Leave a comment:


  • rachot
    commented on 's reply
    Thank you sir.

  • qdrives
    replied
    Zero ohm resistors are often used to allow optional parts or change the signal paths. It allows you to 'disconnect' a part of the circuit.
    A little overkill here in my opinion.

    Leave a comment:


  • rachot
    started a topic R0 ohm

    R0 ohm

    I found this circuit from Antmicro opensource hardware used in Jetson nano base board project.
    Why they put R 0 Ohm in this circuit?
    Thank you
    Last edited by rachot; 04-02-2022, 06:43 AM.
Working...
X