Announcement

Collapse
No announcement yet.

Differential Propagation Delay

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Differential Propagation Delay

    Hi, I'm trying to use the following part to recover and remove jittter from a HDMI clock signal. Looking at figure 4 of the datasheet and the AC electrical characteristics table it can be seen that there is a propagation delay of 1.4ns. How do I adjust the lengths of the other data pairs to compensate the delay on the clock pair?


  • #2
    Hi IMR. I am not sure what you are trying to do, but adding a buffer may not remove jitter. Jitter may be caused by the generator.

    Comment


    • #3
      In a differential routing what does gap actually mean? is it center to center distance or edge to edge?

      Comment


      • #4
        Inner edge to inner edge

        Comment


        • #5
          Is it accepted among different design tools? I am using Mentor Graphics Hyperlynx for stack up design.

          Comment


          • #6
            Gap / clearance is the space between two tracks. It is same understanding / definition in all software (at least in all the software I used including Cadence Allegro, PADS, ...).

            Comment

            Working...
            X