| FORUM

FEDEVEL
Platform forum

Differential Propagation Delay

IMR , 06-21-2016, 09:22 PM
Hi, I'm trying to use the following part to recover and remove jittter from a HDMI clock signal. Looking at figure 4 of the datasheet and the AC electrical characteristics table it can be seen that there is a propagation delay of 1.4ns. How do I adjust the lengths of the other data pairs to compensate the delay on the clock pair?

robertferanec , 06-23-2016, 07:53 AM
Hi @IMR. I am not sure what you are trying to do, but adding a buffer may not remove jitter. Jitter may be caused by the generator.
JohnsonMiller , 07-03-2016, 11:31 AM
In a differential routing what does gap actually mean? is it center to center distance or edge to edge?
mairomaster , 07-03-2016, 03:50 PM
Inner edge to inner edge
JohnsonMiller , 07-04-2016, 01:12 AM
Is it accepted among different design tools? I am using Mentor Graphics Hyperlynx for stack up design.
robertferanec , 07-04-2016, 11:16 AM
Gap / clearance is the space between two tracks. It is same understanding / definition in all software (at least in all the software I used including Cadence Allegro, PADS, ...).
Use our interactive Discord forum to reply or ask new questions.
Discord invite
Discord forum link (after invitation)

Didn't find what you were looking for?