Announcement

Collapse
No announcement yet.

Differential Propagation Delay

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • robertferanec
    replied
    Gap / clearance is the space between two tracks. It is same understanding / definition in all software (at least in all the software I used including Cadence Allegro, PADS, ...).

    Leave a comment:


  • JohnsonMiller
    replied
    Is it accepted among different design tools? I am using Mentor Graphics Hyperlynx for stack up design.

    Leave a comment:


  • mairomaster
    replied
    Inner edge to inner edge

    Leave a comment:


  • JohnsonMiller
    replied
    In a differential routing what does gap actually mean? is it center to center distance or edge to edge?

    Leave a comment:


  • robertferanec
    replied
    Hi IMR. I am not sure what you are trying to do, but adding a buffer may not remove jitter. Jitter may be caused by the generator.

    Leave a comment:


  • IMR
    started a topic Differential Propagation Delay

    Differential Propagation Delay

    Hi, I'm trying to use the following part to recover and remove jittter from a HDMI clock signal. Looking at figure 4 of the datasheet and the AC electrical characteristics table it can be seen that there is a propagation delay of 1.4ns. How do I adjust the lengths of the other data pairs to compensate the delay on the clock pair?

    http://www.ti.com.cn/cn/lit/ds/symlink/ds90lv001.pdf
Working...
X