| FORUM

FEDEVEL
Platform forum

PCB DESIGN RULES

mostafa222 , 01-15-2017, 09:31 AM
Hi dear robert. in altium designer, in pcb design rules, how do you determine the rules priority? for example in open rex board(in below figure) in rules->matched lengths , what rules has higher priority?
robertferanec , 01-16-2017, 02:15 PM
Most of the time, you do not really need to care about priority - it is done automatically in the correct way (or the exact order is not important because they refer to specific groups of signals ... except the main initial rules, which are usually listed as the last one with the highest "Priority number" e.g. clearance all to all). Only if something is not working as you are expecting, then try to play with the priorities.
Use our interactive Discord forum to reply or ask new questions.
Discord invite
Discord forum link (after invitation)

Didn't find what you were looking for?