| FORUM

FEDEVEL
Platform forum

Polygon Pour Clearance

Michael Karl , 08-17-2017, 08:15 AM
Hello
I have a question about flooding planes between VIAs.
In the photo you can see a clearance from 0.07mm. This is for the PCB-manufacturer too small.
Even the DRC could not find this.
I did designs with FPGA and DDR3 where a lot of VIAs are and I have also a lot of this too small clearances between the VIAs.
Can I set somewhere a rule to ckeck this?
Otherwise I have to manually inspect all my planes.

Sorry for my poor english. I am from Austria.

Many thanks in advance
Mike
robertferanec , 08-17-2017, 11:30 AM
We always check this visually/manually. I am not sure if there is a rule for this.
Michael Karl , 08-18-2017, 04:02 AM
Thank you for this advice.
robertferanec , 08-18-2017, 11:02 AM
Maybe you can setup a rule - VIA to VIA and set minimum clearance between them to the value when you know the copper will flow uninterrupted between them. Just an idea.
Use our interactive Discord forum to reply or ask new questions.
Discord invite
Discord forum link (after invitation)

Didn't find what you were looking for?