Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
Hello, any update about how to configure properly the firmware inside 28 pins project board after all changes ?
-
Amazing Robert! Thank you. I was reading about importance of tenting vias as well. I Would like to share the reason i found from an article from pcbgogo...
- 1 like
Leave a comment:
-
So, how can I figure it out? Basically, I just change via settings according to your course hole 0.3mmand 0.6mm diameter but i didnt see any other option....
Leave a comment:
-
How can I get 3D board view without vias?
Hello, Robert. Iam using Altium v21 and I would like to know how can I get a 3D view without visible vias like in your project. I attached a picture from...2 Photos
No activity results to display
Show More
Leave a comment: