robertferanec, it is not via, but pads of two connectors one on top and the other on the bottom side of the board.
And the strange issue, I have...
Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
But what do you think about the logic behind this error?
My suggestion, it looks to be a bug in Altium's DRC engine. If you check the error statement,...
Leave a comment:
-
Abdullah Ansari, the design is a thick 5mm board with a press-fit connector on each side,
Yes, we have to place TH pads on each side and they overlapped,...
Leave a comment:
-
Thank you for your help, using your suggestions I managed to solve the Hole-to-Hole violation.
There is a strange violation! In design, we...
- Likes 1
Leave a comment:
-
Thank you for your suggestions and comments,
- A footprint with a 3D model on both sides won't help, since we sometimes need to make connectors...
Leave a comment:
-
Hole-to-Hole Rules for press fit connectors
I have a thick 5mm PCB with press-fit connectors on both sides, pads are full-stack and is top-to-bottom, pins on both sides have the same net, so electrically...
-
Thank you guys, this export was what I was looking for.
- Likes 1
Leave a comment:
-
robertferanec, is SI tools integrated into the Allegro set or I have to install the Sigrity, along with Allegro?...
Leave a comment:
-
qdrives, thank you for your help. I created the report, but it is still away from what is needed, so possible help for scripting and converting results...
Leave a comment:
No activity results to display
Show More
Leave a comment: