For the other error involving pin 7 on u13, can you share a screenshot that shows both sides of the error indicator?
Also, sometimes when...
Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
-
I have also seen a similar problem where Altium thinks a pad is not connected to a net when it's in the middle of a polygon pour. I have to draw a track...
Leave a comment:
-
It's annoying, but usually when this happens, it's because the track going onto the pad is just short of the center of the pad. Extend the track to the...
Leave a comment:
-
Totally agree with your sentiments on selecting which variant is active. The selected variant should remain active until another is selected
Leave a comment:
-
Altium already has a forum to report bugs and suggest enhancements. I think it's on bugcrunch
Leave a comment:
-
If the large hole is a component and the ring around the large hole is part of the component, then Altium thinks that ring, being part of the component,...
Leave a comment:
-
As Robert writes, this is how you manipulate the view. To adjust the location of the 3D model with respect to the footprint, select the model by left...
- 2 likes
Leave a comment:
-
I recommend finding out what the minimum SM sliver your fab shop can produce. Keep in mind that sometimes fab shop capabilities are so good that they...
Leave a comment:
-
I"m not having an issue. The OP is having an issue where there's a gap between copper objects. Is this the issue you're referring to? If so, please...
-
When connecting two pads with a track, it's risky, and in some cases invites errors, if the user only brings the track to meet the edge of the trace....
Leave a comment:
-
Regardless of the object type, polygon, solid region, fill, etc., if they only meet edge to edge, there's a risk of a gap....
Leave a comment:
-
I've been burned by this before. If the boundary of one copper feature is numerically less than the boundary of the other copper feature by some tiny...
- 1 like
Leave a comment:
-
This often happens to me. There are a variety of settings. Check that pour over all same-net objects is selected? If the polygon is small, make sure...
- 1 like
Leave a comment:
-
Seems like you should invite your PCB manufacturer to this conversation....
Leave a comment:
-
Since you know the Saturn PCB tool, you should be able to use it to see how you can reduce the width of the traces. As mentioned, if you decrease the...
Leave a comment:
-
Saturn PCB has a pretty good tool/calculator for this. You can enter the values you are currently using for your design and see what the resulting impedance...
Leave a comment:
-
The pink rings around the IC pads illustrate how far beyond the IC pad copper the solder mask will be pushed from the pad. The opening in the solder...
Leave a comment:
-
It seems like the biggest benefit to deleting stuff is to free up drive space. This was particularly important at the turn of the century when most computers...
- 1 like
Leave a comment:
No activity results to display
Show More
Leave a comment: