' and ì: the two keys...
Lucky-Luka
Member
Last Activity: 02-26-2021, 02:21 AM
Joined: 11-07-2020
Location:
-
Thanks for the solution but I have finally found the right 2 keys!!! I have looked for them everywhere and I've found them.
' and ì: the two keys... -
I cannot vary the intensity of the shading.
Fortunately right now I think it's acceptable. Even if I don't know how it turned from very dark to...Last edited by Lucky-Luka; 02-17-2021, 04:07 AM.Leave a comment:
-
It doesn't work. Somehow now it's not black as in the original post while I trace but I haven't understood why. If I start a trace and keeping pressed...Leave a comment:
-
What is the exact procedure to follow? in my keyboard I have to press altgr key and [ or ] to have [ or ]...Leave a comment:
-
How to route traces without losing the sight of everything?
Hi all
When I try to route traces everything turns black except the initial and final pad. How can I see everything?
Thanks... -
component clearence constraint
Hi all
Why is there an error regarding a collision if the silkscreen is not touched but only the perimeters of the components are touching?
...Last edited by Lucky-Luka; 02-16-2021, 11:11 AM. -
I've disassembled the footprint and I've found a track under every first pin of the headers!
I haven't drawn them consciously...
Mistery...Leave a comment:
-
track width error
Hi all
I've placed all the components in the PCB. I've run the DESIGN RULE CHECK.
I've got width constraint error... I cannot understand it... -
I've downloaded an Altium 21 trial version.
The problem is gone. I still would like to know why I had that problem...Leave a comment:
-
Altium 19 CRASH
Hi all
After I've completed the schematic I've compiled it and then i've selected the voice UPDATE PCB DOCUMENT under TOOLS.
Then EXECUTE...Last edited by Lucky-Luka; 02-15-2021, 08:54 AM. -
BOM question
Hi all
In Altium 19, in the section CONFIGURE of the output job file, I cannot find the column named category present in Altium 15. That column... -
3D models in Altium 19
Hi all
Is there a way to orient the view?
How to properly move the IC respect the pin holes? Using the coordinates in the properties tab?...
No activity results to display
Leave a comment: