Thank you @Lakshmi and @robertferanec.
I gauss just go with the safest way, and try not to do it.
Regarding the clearance, yes, I have increase...
11 results in 0.0165 seconds.
-
Right Corners in Polygons/Power Layer
Hi Everyone!
I am an engineer in a hardware R&D company, and we have two teams related to right corners in polygons, which are:
...Last edited by tariq1996; 03-02-2021, 06:03 AM. -
Editing Components in Layout
Hello there,
I have a small issue here, which is, if I have a rule violations about (Silk To Solder Mask), then, I need to change the silk of the... -
YES, it worked.
Thanks mr.RobertLeave a comment:
-
address, command and control group. please, see the attached figure.
The HDMI signals. see the attached figure ple...Leave a comment:
-
Hello Robert again,
Regarding the next activite (4), I have multiple of questions:
1. I have set up the rule for the length matching...Leave a comment:
-
Length Matching (Layout Advance Course) APLC 6
Hello Robert,
I have watched your method about length matching the address, command and control group which is the third activite. But,... -
Thank you all....Leave a comment:
-
Signals Travel In Different Speed
Hi Robert,
I would like to ask about some information you spoke about it in lesson 4 of Advance pcb design course.
You said " The signals... -
Thank you Mr.Robert....Leave a comment:
-
Advance Layout Course (Lesson 2) Memory Signals
Hello everyone,
In the Advance layout course (Lesson 2), I would like to ask that:
Why did mr.Robert make some memory signal in the...
Leave a comment: