24 results in 0.0130 seconds.
-
In my knowledge This is looks like an impedance rule what you did set up earlier. You might have to change the track width to get the impedance what you...Last edited by ZsoltFulop; 05-11-2021, 12:00 AM. -
Thank you I will do.
I have got one more question which is about the VIA.
On the course you did talk about we have to make sure about the... -
Thank you very much.
I will learn it anyway,just wanted to know what can I expect from the course
-
I have got one more thing which is not clear for me:
is it only voluntary activity to do the baseboard?
So when I will finish the course and... -
Thanks for your reply.
I already completed the beginner courses,and currently on the Advanced courses.
I was just wondering if the OrCad course...Leave a comment:
-
Orcad software learning after Altium courses
Hi
I am planning to do Orcad courses in the future.My question is: Is there too much difference between the Altium and the OrCad or its going to... -
Thanks for the answers.
It was a bit confuse me as it saying "for this week activities you have to work on ... files" .
So if I...Leave a comment:
-
Advanced PCB Layout Activities question
Hi
I am little bit confused with the activities in Advanced PCB Layout course,
Do I have to do my own project and route everything,or I always...Last edited by ZsoltFulop; 03-06-2021, 12:38 AM. -
DRC checking pops up
Hi
When I am working on the PCB this DRC checking always pop up after almost every command and slows down my computer. Is there any way to turn... -
Many thanks,
I will have a look on it....Leave a comment:
-
Power width rules issue
HI all
I was set the Power width rules for 0.4mm, first I was try to write to the custom query: InNet ('+') OR InNet('GND') but it doesnt work,...Last edited by ZsoltFulop; 03-06-2021, 04:41 AM. -
Many thanks, I was using the values from "Learn Altium Essentials" course,so it was OK.
I just would like to mention it, just in case...Last edited by ZsoltFulop; 01-18-2021, 09:22 AM.Leave a comment:
-
Thanks your reply,I done it but looks like it does not set it in order.
Only the error message pop up,so hopefull not going to cause big troubles... -
Error when compile the given files
Hello
I have a problem when I copied the given files to my project folder as it was on the video(around 10 minutes in Lesson6 Learn to design our... -
Pin size Differences between courses
Hi.
I watched the 'Learn Altium Essentials' course for first and now I am on the 'Learn to design your own board' course. I realised on the 'Design...
Leave a comment: