Hello,
robertferanec , i watched your vedeo about the EMI-EMC improuvement and i want to ask about the software used for the simulation....
17 results in 0.0150 seconds.
-
-
Encoder and Hall Sensors
Hello, I have a brushless dc motor and i want to read data from it's encoder and hall sensor. My problem is that i'm not sure if i can connect the outputs... -
STM32 Firmware
Hello robertferanec did you have any vedeo/ Tuturials about how to develop a firmware from scratch using c language for stm32 microcontroller??... -
my board is talking to a pc -
the cable is <1 m -
yes i added the 120 ohm resistor -
RS485 Baud rate
Hello there, i have designed a board with RS485 communicatin . i have used the MAX485 IC . My problem is that the communication is working very well when... -
PCB Box
Hello,
I need to design box for my board ( made with Kicad) . i'm confused between using fusion360 or Designspark mechanical . Because it's my... -
Hello qdrives,it's RS485 half duplex bus (D+,D-). I use this tranciever SN65HVD3082EDGK. -
Thank you Robert, the board is conncted to a pc and 2 driver motor via the RS485 bus. The problem is that i don't know how to configure and programming...Leave a comment:
-
RS485 with STM32
Hello everyone,
Please to configure RS485 bus witht stm32 using the stm32CubeIDE. I need the RS485 to communicate with some devices in my... -
soldering
Hello ,
I recently recieved my board and i should soldering components. Please do you recommand that i started with the cpu soldering or i should... -
VIA Stitchng
Hello there , a via stitching is it used just for cooling a component (regulators for exemple ) or it has other utilisations . Also, a stitching via... -
track width
Hello , i'm working on a board that should support 24 V/ 8A so please can someone help me how i can fix the tarck width to support 24V/ 8 A ? -
thank you very muchLeave a comment:
Leave a comment: