16 results in 0.0108 seconds.
-
Done and thank you for sharing! -
I just finished the course today! Do files or anything need to be sent for verification of completion?Leave a comment:
-
In mine, sub-drawing is the clipboard. On to final lesson!Leave a comment:
-
Lesson 11 about 1 hour 35 minute in, we are copying the MFG Notes from the clip board. I cannot find clipboard. It isn't in my export tab. I attached...
Leave a comment:
-
I found out why the description was not showing up. It was a misspelling.Leave a comment:
-
I am still unable to find the finished schematic. I found the pdf version. My cover page doesn't have a title block at the top for this reason.Leave a comment:
-
All previous errors I was having are corrected. In lesson 7, ,about 35 minutes in, we are creating the BOM. I created the BOM using the 2 lines from...Leave a comment:
-
I always go full screen and didn't see the files and download tabs. Thanks!Leave a comment:
-
Also the course files that you refer to when doing the BOM, I can not locate those. Were they to be downloaded ?Leave a comment:
-
When I tried changing the height value to zero, I get an error saying it must be greater than 1. I attached a screen shot of the error.
It...Last edited by rahnkt; 06-01-2021, 05:37 AM.Leave a comment:
-
Lesson 6, about the 45 minute mark, we are creating thru_d4mm_h1mm5. When I get to the 3D models, after removing the capacitor, this is what I get. ...
Leave a comment:
-
Thank you! I looked at that but didn't think it was the right place to do thatLeave a comment:
-
Here is my full screen...
Leave a comment:
-
Yes, the part properties is not selectable. Part properties is docked on the right side of my screenLeave a comment:
-
This is when adding the attached users properties. I attached a screen shot. I see your example works for doing like the components on the board....
Leave a comment:
Leave a comment: