56 results in 0.0142 seconds.
-
From micro to each socket, 3 cmLeave a comment:
-
Draw Pcb of MMC Reader
Hi Dear Robert.
I Have two MMC Socket that i want to connect them to MMC Port Of Microcontroller like below picture.
at one moment, only one... -
Thanks so muchLeave a comment:
-
Thats the problem. Im not sure were is the problem. I tune all signals and only im not sure about the way i tune the signals. I use altium length tunning...Leave a comment:
-
gigabit ethernet layout
Hi. I draw my gigabit rgmii signal as follow and i tune the lengths of signals. But my phy only work on 100 base ethernet and didnt work on 1000 base.... -
Thanks. But i want to know the male edge connector pinout and signal nameLeave a comment:
-
pcie
Hi.i am designing a custom board with ti processor. it support a x2 pcie. I want to connect it to an pcie edge connector like one in picture below. But... -
Thank you so much.Leave a comment:
-
I have 2 question:
1: how can i add ibis model to hyperlynx?
2: i want to simulate hdmi data port between fpga and hdmi chip. Should i have...Leave a comment:
-
Ok. Thank you so muchLeave a comment:
-
Where can i find ibis model?Leave a comment:
-
pcb simulation
Hi. I designed a ddr3 board with altium. I want to simulate my pcb to see if my pcb working correctly. Somebody tell me to use hyperlynx program to simulate... -
Thank you so muchLeave a comment:
-
length tunning
Hi dear robert. I tuned my ddr3 data track within each bank but each bank have diffrent track size. Is it necessary to make all bank size the same? Or...
Leave a comment: